Citroen Xantia

since 1993 of release

Repair and car operation


Citroen Xantia
+ Introduction
+ Operation manual
+ Routine maintenance
+ engine Repair
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Coupling
- Transmission
   - Manual box of gear shifting
      Replacement of transmission oil
      Drive of the mechanism of gear shifting - the general information and adjustment
      Removal and installation of components of a drive of gear shifting
      Replacement of epiploons
      Check of serviceability of functioning, removal and installation of the sensor switch of fires of a backing
      Removal and installation of a drive of a speedometer
      Removal and transmission installation
      Major maintenance of RKPP - the general information
   + Automatic transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ electric equipment Schemes

Check of serviceability of functioning, removal and installation of the sensor switch of fires of a backing

Check

 PERFORMANCE ORDER

1. Management of functioning of fires of a backing is carried out by means of screwed from above in a case of transmission of the sensor switch of plunzherny type. In case of violation of functioning of fires, first of all check a condition of the corresponding safety lock.
2. For check of the sensor switch disconnect from it electroconducting. By means of an ohmmeter or a lamp sampler make sure available conductivity between sensor switch plugs at a choice to a reverse gear. At negative result of check and lack of visible defects of electroconducting of the corresponding contour it is necessary to replace actually the sensor switch.

Removal

 PERFORMANCE ORDER

1. For the purpose of ensuring access to the sensor switch, depending on a model complete set, remove an inlet air line (ы) (see. Head of the Power supply system and release) and the battery with the basic pallet (see. Head engine Electric equipment).

2. Disunite the electric socket, then turn out the sensor switch and remove it from a transmission case together with a sealing washer.

Installation

 PERFORMANCE ORDER

1. Replace a sealing washer, then screw the sensor switch on the regular place in a transmission case. Tighten the sensor with demanded effort.
2. Restore initial connection of electroconducting, establish on a place and connect the battery / an inlet air line (ы). Check serviceability of operation of fires of a backing.






QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE